Here is a build of the Morbid Fur fuzz. There were a few errors in my first version of this PCB. All my fault. I had these boards manufactured at PCBWay. com. They do great work and have many options to choose. Like solder mask color. I wrote about their service in more details in a previous post.
This time through everything worked well. This board went together well and fired up the first try!
I followed the off-board wiring scheme used by PedalPCB with all LED mounted to the board, power at the top and the rest of the wiring on the lower edge. All of the wires that go to the switch are on a neat row where the wires can all run parallel to the switch. This arrangement makes wiring a breeze and the layout neat and tidy.
Build your own
You can order boards from PCBWay.com here.
BOM
| Part Number | Value |
| C1 | 220n |
| C2 | 470p |
| C3 | 150n |
| C4 | 150n |
| C5 | 470p |
| C6 | 470n |
| C7 | 150n |
| C8 | 470p |
| C9 | 470n |
| C10 | 220n |
| C11 | 47µ |
| D1 | 1n4001 |
| D2 | LED 3mm Red |
| D3 | LED 3mm Red |
| D4 | 1n4742 |
| D5 | 1n4742 |
| D6 | LED |
| Q1 | BC337 |
| Q2 | BC337 |
| Q3 | BC337 |
| R1 | 33K |
| R2 | 82K |
| R3 | 120r |
| R4 | 470K |
| R5 | 18K |
| R6 | 1K |
| R7 | 8K2 |
| R8 | 56K |
| R9 | 100r |
| R10 | 470K |
| R11 | 10K |
| R12 | 8K2 |
| R13 | 82K |
| R14 | 120r |
| R15 | 470K |
| R16 | 18K |
| R17 | RLED ~1K |
| VOLUME | A100K |
| GAIN | A100K |
Parts Placement
Wiring
Schematic
Drill Guide
Note! You will need to check the size with your print to make sure it prints to the correct size!
Wiring
Leave a Reply